​​روغن قالب پایه آب OFZ315

Water-based Mold oil OFZ315

In order to make a suitable concreting, it is necessary to respect all standard principles from the selection step and mixing of materials up to processing and maintenance of concrete. Concrete framing is one of the most important steps in this process which is performed by the help of metallic or wooden and even plastic frames. The surface of frame should be so much qualitative in a way that concrete could be released as easily as possible. Also low quality of frame should not effect on concrete surface by removing or making porosity. For this purpose, it is necessary to lubricate the surface of concrete frames prior to concreting by a specific material. There is a mold oil product which is based upon water and makes an emulsion oil for providing a thin layer on the metallic or concrete and/or wooden frames. It may cause further easier separation of concrete. The other advantages of soluble mold oil is lack of any superficial bubbles. Burned oil was used in traditional methods for lubricating the surface of frames which is not used anymore today. Some of the other advantages are easy movement of air bubbles close to frame upon opening the frame and no more color change and lack of adhesion of color or modifiers and stoppers.

Packing: 20 Liter galloon​​​​​​​

Mode: Liquid (Milky)
Soluble in water​​​​​​​

Special weight: 0.85 gr.cm3
Chloride Ion: ---

Standard: CE204 CE1407

Properties & effects:

No more needs to shock for separation of concrete from frames
Easy movement of air bubbles near to frames
Easy cleaning of tools and frames by water
Prevention from any color change at concrete surface
More economic than similar methods
Suitable & acceptable coverage on surface of molds
Increasing the life span and durability of concrete molds
No more needs to cleaning & separation of concrete on surface of molds
Lack of pollution and /or negative effects
Lack of negative effects on adhesion of color or water stop mortars
Non-poisonous and inflammable
Providing concrete with smoother level in comparison with framing without applying of mold oil

Consumption method:

It is recommended to turn the container containing the product several times before using the mold oil or to stir it mechanically, if possible, at the same time.
One unit of solvent-based mold oil can be combined with 50 to 100% of oil products such as gasoline.
It is better to remove any dusts or concrete/ cement from frames prior to applying of solvent-based mold oil.
In case of any remained concrete or mortars on the surface of frames, please remove the same by water jet and/or sand blast as well.
In case of any concrete or mortar stains on frame surface, please remove the same by the help of metallic tools.
Then apply the solvent-based mold oil by a roll or brush or spray.
Solvent-based mold oil is also applicable in pure form.

Consumption rate​​​​​​​

It depends upon the type of frame and porosity rate of the frame.
In normal condition, by adding 0.5 to 1 liter of oil solvents to 1 liter of mold oil, it is possible to cover about 10-12 square meters.